This step involves the windshield and some adjacent parts.
Here is the gallery of 20 images.
I’m in the home stretch with this kit; the remaining steps involve the windows and other small details. Here are some comments about this step in particular.
- The kit comes with pre-cut window masks which make it easier to paint the black border around the front and rear glass.
- It wasn’t clear what was to be done about the sun visors. There are two large ejector pin marks on each one (which I left alone), and they’re largely obstructed by the frame above them once glued in place.
- The rear view mirror was knocked off several times while trying to position things. It’s held in place for the moment with poster tack until the body piece is completely done (more steps following this one). Once glued, I’ll use white glue so I don’t have to worry about marring the plastic windshield.
- The decal near the rear view mirror tore while positioning it and trying to affix the mirror. I hand-painted the gaps and what tore off. I’m not very pleased with how it looks, but it’s better than nothing.
- The window cowl (where the wipers sit) fit into the body as expected; however, the windshield did not fit well onto the cowl. About 45-60 minutes alone was spent trying to get masking tape to hold the window in a good enough position to apply glue in stages. Normally Tamiya kits have excellent fit. I used cement glue specifically for clear parts.
- The black triangular panels near the trunk are glued from underneath. I used Tamiya Extra Thin for one side and found it bled out from the seams, marring the paint (on the body and the part itself). Some hand painting mostly addressed the blemish. I used a thicker cement on the other panel that wasn’t applied at the seam.
- Gluing the windshield occurred in two phases: the bottom at the cowl and near the sun visors. Masking tape worked well to hold things in place while the glue cured.
- Although there are gaps in certain areas around the windshield, the interior of the car is black which should help hide those gaps.
Lessons learned this step
- Apply more coats of black paint on the masked windows to make it opaque. Currently it looks like a dark tint.
- The instructions imply you should glue the rear view mirror to the decal with cement. This is a weak bond, and repositioning it tore the decal.
- Perfect is the enemy of good. There are compromises I made knowing that the effort to fix them wasn’t worth the delay in finishing the kit.
- At several points in this step, I wondered whether I should have assembled first (rather than painted first). I think the effort would have been about the same.
- Making a mistake on one side of the vehicle allowed me to avoid the same mistake on the other side.
This step took about 2.5 hours.
